Tesa grip for your hula hoops

Item sold individually (1 roll). Length of tape on a roll: 25 meters.

Fluorescent hula hoop tape:

This tape is the one that is mainly used for hula hoops. It can also be used for the center of your clubs, to make the connection between the handle and the body. The 25mm version may be a little too large for clubs, opt for the 19mm version instead.

How to apply the tape?

To apply it, you must first lay a length of a few centimeters, then maintain pressure by pulling on the roll while you lay it down. If you pull too much, the tape can break. This tape is not elastic, it will be difficult to follow shapes that are not flat (with x and y twist). It will have excellent performance if you have a rounded surface (only on an axis like on a hula hoop).

If you can heat the tape slightly once it is in place, this will set the glue, for a better hold. For clubs, squeeze them very tightly between the thumb and forefinger where the tape is applied and rotate the club until heat is released with the friction. This may sound amateurish, but if you have nothing to heat (contactless), it's terribly efficient! You can do the same on a hula hoop.

Use this tape for your hula hoops:

This tape can be used to decorate your hula hoop, its 25mm width is ideal.

Characteristics and compatibility:

Its special feature is that it does not ooze, unlike most adhesive tapes that you find in DIY stores. That is to say that if you leave your equipment in the sun, this adhesive tape will not leave you dripping glue that sticks to your fingers on your equipment!